Mahdi Seyfollahi; Habib Etemadi; Reza Yegani; Mahyar Rabeii; Elham Shokri
Abstract
In this study, membranes were prepared by pristine and polyethylene glycol (PEG)-grafted nanodiamond (ND) embedded in cellulose acetate (CA) as matrix polymer via non-solvent induced phase separation method. The antifouling properties of the membranes were studied during filtration of ...
Read More
In this study, membranes were prepared by pristine and polyethylene glycol (PEG)-grafted nanodiamond (ND) embedded in cellulose acetate (CA) as matrix polymer via non-solvent induced phase separation method. The antifouling properties of the membranes were studied during filtration of bovine serum albumin (BSA) solutions and the governing fouling mechanisms of the membranes were also investigated using the Hermia model. Fourier Transform Infrared Spectroscopy (FTIR) and Thermal gravimetric analysis (TGA) confirmed that ND was successfully functionalized by PEG. CA/ND-PEG nanocomposite membranes have higher hydrophilicity, porosity, water uptake, mechanical strength and a lower amount of adsorbed protein than pure CA and CA/ND membranes. Besides, the antifouling performance of the CA/ND-PEG (0.5 wt.%) nanocomposite membrane also witnessed considerable improvement, in comparison with that of pure CA and CA/ND (0.5 wt.%) membranes. The obtained results showed that the best fit to experimental data for all membranes (pure and nanocomposite membranes) corresponds to the cake layer formation model.
Eman Serag; Ahmed El Nemr; Azza El-Maghraby
Abstract
A novel Graphene oxide-polyethylene glycol and polyvinyl alcohol (GO-PEG-PVA) triple network hydrogel were prepared to remove Copper(II) ion from its aqueous solution. The structures, morphologies, and properties of graphene oxide (GO), the composite GO-PEG-PVA and PEG-PVA were characterized using FTIR, ...
Read More
A novel Graphene oxide-polyethylene glycol and polyvinyl alcohol (GO-PEG-PVA) triple network hydrogel were prepared to remove Copper(II) ion from its aqueous solution. The structures, morphologies, and properties of graphene oxide (GO), the composite GO-PEG-PVA and PEG-PVA were characterized using FTIR, X-ray diffraction, Scanning Electronic Microscope and Thermal Gravimetric analysis. A series of systematic batch adsorption experiments were conducted to study the adsorption property of GO, GO-PEG-PVA hydrogel and PEG-PVA hydrogel under different conditions (e.g. pH, contact time and Cu2+ ions concentration). The high adsorption capacity, easy regeneration, and effective adsorption–desorption results proved that the prepared GO-PEG-PVA composite hydrogel could be an effective adsorbent in removing Cu2+ ion from its aqueous solution. The maximum adsorption capacities were found to be 917, 900 and 423 mg g–1 for GO-PEG-PVA hydrogel, GO and PEG-PVA hydrogel, respectively at pH 5, 25 °C and Cu2+ ions’ concentration 500 mg l–1. The removal efficiency of the recycled GO-PEG-PVA hydrogel were 83, 81, 80 and 79% for the first four times, which proved efficient reusability.